← Stalls while driving on all engines
Symptoms · ProMaster 3.6 (gas)
ProMaster 3.6 (gas): stalls or dies while driving
2 documented failures on this engine list this among their signs. They are ordered from the most widespread down. Each one shows the signs in its record's own words, how to tell it from the others, the usual fix and any recall or bulletin.
Not sure which engine you have, or want the recalls for your exact truck? Check your VIN: it names the engine and lists the campaigns for that model year. Whether a recall is still open on your VIN: nhtsa.gov/recalls.
aggregated
How widespread: Occasional
19 NHTSA owner complaints match it, out of 459 checked
How it shows up
- stalls under load or at idle
Its other signs
- long crank / hard start, worse low-fuel
- fuel pressure below spec
How to tell it apart
- log fuel pressure at rail vs spec under load and prime
- verify voltage/ground at the module connector
- replace the module per the tank variant; new o-ring and lock ring
Usual fix
fuel pump module replacement (tank variant matters) with new o-ring
Root cause, parts and sources →
aggregated
How widespread: Occasional
13 NHTSA owner complaints match it, out of 459 checked
How it shows up
- cam/crank correlation DTCs, hard start or stall
Its other signs
- phaser/limp codes on the VVT side
- intermittent no-start that returns
How to tell it apart
- read correlation DTCs and live cam/crank data
- actuate the phaser solenoid; check screens for debris
- replace per DTC direction; verify battery health first
Usual fix
cam/crank sensor or phaser actuator replacement per DTC
Root cause, parts and sources →
Other symptoms on the ProMaster 3.6 (gas)
Hard start, long crank or no-startLoss of power, limp mode or derateLosing coolantMisfire, rough idle, hesitation or surging
Everything on the ProMaster 3.6 (gas)Its recalls and bulletins